Ways to Squeeze More Storage Out Of Small Spaces
Olivia Owen 3/15
Tight-Space Shelves
Wire pantry shelves aren’t just for pantries. They’re perfect for any wall where full-depth shelves won’t fit: garages, laundry rooms, utility rooms, etc. The perfect space-saving shelves solution.
4/15
Make the Most of Skinny Spaces
In a small kitchen with little storage space, you can make even narrow filler spaces work harder by installing a vertical pegboard rollout. Kitchen designer Mary Jane Pappas typically recommends 18- to 30-in.-wide rollout drawers for cabinets.
But there is one type of rollout that makes good use of narrow spaces, even those only 3 to 6 in. wide. Pappas says that pullout pantries– single tall, narrow drawers with long, shelves, drawers, baskets or even pegboard – can be an efficient way to put skinny spaces to work.
5/15
Stud Space Cabinet
When you can’t find a convenient nook for a set of narrow storage shelves, you can often create one by recessing the shelves into the wall itself. Choose the location for your shallow shelving unit before you build the project to make sure it will fit. Start by looking for a space with no obvious obstructions.
Next, locate the studs with a stud finder. Some stud finders can also locate electrical wires and plumbing pipes inside walls. When you’ve found a promising spot, cut a 6-in.-square inspection hole between the studs. Use a flashlight and a small mirror to inspect the stud cavity for obstructions. You often can modify the size of the cabinet to avoid obstructions.
When you find a good space, mark the perimeter of the opening and use a drywall keyhole saw to cut it out. Measure the opening and subtract 1/4 in. from the height and width to determine the outer dimensions of your behind the door shelves. For standard 2×4 stud walls with 1/2-in.-thick drywall, build the cabinet frame from 1x4s that measure 3-1/2 in. wide (see illustration). If your walls are different, adjust the depth of the frame accordingly. Then add a 1/4-in. back. We screwed 1/4-in. pegboard to the back so we could hang stuff from pegboard hooks.
Add casing that matches the trim in your house. Drill holes into the sides to accept shelf supports. Shelf supports fit in 3mm, 5mm or 1/4-in. holes depending on the style. Install the cabinet by slipping it into the opening, leveling it and nailing through the trim into the studs on each side. Use 6d finish nails placed every 12-in. along both sides.